Dodge Charger Chrysler 高速配送 300 Challenger お得 kit pedal stainless pad

Dodge Charger Chrysler 300 Challenger stainless pedal pad kit

www.rosemaryrideoutphotography.com,300,車＆バイク , カーパーツ , 内装パーツ , ペダル,Chrysler,pad,kit,Charger,8556円,Dodge,Challenger,pedal,stainless,/arundineous715742.html 8556円 Dodge Charger Chrysler 300 Challenger stainless pedal pad kit 車＆バイク カーパーツ 内装パーツ ペダル Dodge Charger Chrysler 300 Challenger 【お得】 kit pedal stainless pad 8556円 Dodge Charger Chrysler 300 Challenger stainless pedal pad kit 車＆バイク カーパーツ 内装パーツ ペダル www.rosemaryrideoutphotography.com,300,車＆バイク , カーパーツ , 内装パーツ , ペダル,Chrysler,pad,kit,Charger,8556円,Dodge,Challenger,pedal,stainless,/arundineous715742.html Dodge Charger Chrysler 300 Challenger 【お得】 kit pedal stainless pad

8556円

Dodge Charger Chrysler 300 Challenger stainless pedal pad kit

Dodge Charger Chrysler 300 Challenger stainless pedal pad kit

High quality that exceeded my expectations
I ordered these bright pedals for my 2016 Dodge Challenger. They arrived on time like stated. Great looking product. Gas pedal snaps on very easily.There is a little struggle with the brake pedal, but after doing some research just drop it in some hot almost boiling water for a few minutes then dry it and it will slip on very easily. Took me less than 5 minutes to install after using the hot water method on brake pedal. Thanks MOPAR
These peddle covers look and feel great. They are not as shiny as in the picture but still look great.The cover for the gas is very easy to install, it just snaps in place. The hard one is the brake. You will need the the following: hand sanitizer, hot water, a set prying tools from harbor freight ($6.00).1. Place cover in hot water, this will soften the rubber.2. Remove old peddle cover3. Remove cover from water and shake out the water4. Apply lots of the hand sanitizer to the rubber this will help it to slide on, start at the top and work the sides5. Use the prying tool of your choice to work the final part of the peddle cover over the peddle. This will take a little effort so take your time.
2017 Challenger RT - Took me 5 minutes to install. The accelerator pedal cover just snapped on in less then a minute. The brake pedal took a few minutes. I took off the stock pedal cover, grabbed the new cover and stretched the top corners out so when I slid the top on the top, corners and the side corners slide on. I then grabbed the sides from the bottom on each side and stretched them open, one side in each hand and pushed forward and the sides popped on. I then used a small 90 degree L bracket used for shelves and slide it up and over on the inside bottom. Once in I slid it all the way down until the bottom was on. No hot water or oil used.

新着情報

カテゴリー別新着一覧

RANKING 記事ランキング

TO TOP